Panasonic AJ-D400P Service Manual - Audio Function Section (1)
13 (E)
Audio Function Section (1)
r
AUDIO LEVEL CH1 (audio channel 1 recording level) control
When the AUDIO SELECT CH1/CH2 switch
u
is set to MAN, the recording level of audio
channel 1 can be adjusted by this control in addition to the AUDIO LEVEL CH1 control
t
on
the side panel.
s
MIC IN (microphone input) jack (XLR, 3-pin)
Connect an optional microphone to this jack. The power for the microphone is supplied from
this jack.
Audio Function Section (2)
t
AUDIO LEVEL CH1/CH2 (audio channel 1/2 recording level) controls
When the AUDIO SELECT CH1/CH2 switch
u
is set to MAN, the audio level of audio chan-
nels 1 and 2 can be adjusted using these controls.
However, the audio CH1 level can also be adjusted using the AUDIO LEVEL CH1 control
r
on the front panel.
u
AUDIO SELECT CH1/CH2 switch (audio channel 1/2 auto/manual level adjustment se-
lector) switch
This selects the method used to adjust the audio levels of audio channels 1 and 2.
AUTO: For adjusting the levels automatically.
MAN:
For adjusting the levels manually.
v
AUDIO IN (audio input selector) switch
This selects the input signals to be recorded on audio channels 1 and 2.
FRONT [MIC]: The microphone input signals connected to the MIC IN jack
s
are recorded.
REAR [MIC]:
The microphone input signals connected to the AUDIO IN CH1/CH2 connec-
tors
w
are recorded.
REAR [LINE]:
The line input signals connected to the AUDIO IN CH1/CH2 connectors
w
are recorded.
w
AUDIO IN CH1/CH2 (audio input channel 1/2) connectors (XLR, 3P)
An audio component or microphone is connected here.
x
AUDIO OUT connector (XLR, 3P)
This is connected to an audio component. The audio channels can be selected on the setting
menu.
y
DC OUT (DC power output) connector
This is the DC 12 V output connector. A current of approximately 100 mA can be taken out.
s
r