Panasonic AJ-D400P Service Manual - Setting The User Bit

77 (E)

Setting the User Bit

Setting the user bit allows up to 8 digits of hexadecimal data such as memos (date, time), etc. to

be recorded in the sub code track.

1

Set the DISPLAY switch to UB.

2

Set the TCG switch to SET.

3

Set UB MODE on the FUNCTION 3/5 page of the setting menu to REAL.

4

Set the user bit using the SHIFT/ITEM, UP and DOWN buttons.

SHIFT/ITEM button: This is used to cause the digit which is to be set to flash. Each time it

is pressed, the flashing digit moves to the right.

UP/DOWN buttons: These increment/decrement by 1 the figure of the flashing digit.

The hexadecimal characters A to F appear as follows.

5

Set the F-RUN/R-RUN switch to F-RUN or R-RUN.

User bit memory function

The user bit setting (except for the real time) is automatically stored in the memory and held

even after the power is turned off. However, care should be taken as the settings are not stored

in the memory if the time from when the power was turned on until the setting operations are

completed and the power is turned off is less than 20 seconds.

Hexadecimal

A

B

C

D

E

F

Display

2,5

1

4