Q-See QS434 User manual - Device Operation
DEVICE OPERATION
Model #: QS434
7 |
P a g e
3.2 REMOTE CONTROL
The remote control is the secondary input device
For navigating the system’s menus.
To use the remote control:
1. STANDBY: Press to turn standby mode ON/OFF.
2. LOGIN/LOCK: If "Security" has been enabled in the
Setup menu, press to open the user password login
screen.
3. Number/Channel buttons: While in menus,
press buttons 0~9 to enter values; during live
viewing, press to view channels full-screen.
4.
: Press to switch between quad and
full-screen displays.
5. MENU: Opens the main menu.
6. PTZ: Press to open the PTZ control window.
7. EXIT: Close menu windows.
8. Navigation/OK:
/CH+: Move cursor in menus up; Channel Up.
/FWD: Move cursor in menus to the right; during
playback, increase forward playback speed (5X, 15X,
60X).
/REW: Move cursor in menus left; during playback
increase reverse playback speed (5X, 15X, 60X)
/CH-: Move cursor in menus down; Channel down.
OK: In menus, press to confirm selections; during
playback and preview, press to view system
information
9. +/ - : In menus, press to adjust values.
10. RECORD: Press to start manual recording.
11. STOP: Press to stop manual recording.
12. EXTRA: For future use.
13. Playback controls:
• : Increase reverse playback speed 1X, 2X, 4X
• : Press to start playback
• : Press to increase forward playback speed 1X, 2X, 4X
• : Press to slow playback speed by 1/2, 1/4, 1/8
• : Press to freeze playback to one frame, then press again to advance frame-by-frame
TIP: When using the remote control to
enter password and camera titles, select
the field using the navigation buttons,
press ENTER, and then press the number
buttons.