Q-See QS434 User manual - Device Operation
DEVICE OPERATION
Model #: QS434
35 |
P a g e
Figure 3.5.35
Figure 3.5.36
UPNP
UPnP Forum is an industry initiative designed to enable simple and robust connectivity among consumer electronics,
intelligent appliances and mobile devices from many different vendors. As a group, we are dedicated to making the
connected home and lifestyle mainstream experiences for consumers - and great opportunities for the industry.
NOTE: Your Router needs to support UPNP function.
To configure UPNP settings:
1) Enable the UPNP function in your Router.
2) Under DVR GUI
,Open the MAIN MENU and click ADVANCE.
3) From the Advanced Setup menu, click NETWORK.
4) Under UPNP, select OPEN.
5) Click APPLY to save your settings and then click OK in the confirmation window.
6) Using a remote PC, open Internet Explorer.
7) In the address bar, enter your Router WAN IP address immediately followed by :WEB PORT (no spaces).
http://XXX.XXX.XXX.XXX(Router WAN IP):XXX(WEB PORT)
8) Enter your system ADMIN password and select INTERNET.
NOTE: If you have not enabled passwords on the system, leave the password field blank.
9) Click LOGIN.
Static IP
You will need to setup the network settings on the DVR to match the settings of the router that you attach the DVR to.
To get the router settings you would go to the run option on a computer attached to the same router as the DVR and
type cmd and hit OK to bring up a command prompt (Figure 3.5.37), then type ipconfig at the prompt (RED arrow on
Figure 3.5.37) to access the router settings. Write down the gateway and subnet mask numbers (GREEN arrows on
(Figure 3.5.37) so you can copy them into the network settings on the DVR (GREEN boxes on Figure 3.5.38). Push
the MENU key on the DVR to get to the System menu, then the Advanced option, and then the Network option to
display the NETWORK screen shown in Figure 3.5.38.