Q-See QS434 User manual - Device Operation
DEVICE OPERATION
Model #: QS434
19 |
P a g e
3) Under QUALITY, select BEST, FINE, NORMAL. Setup code rate for recording,
CIF: corresponds to 768Kbps and 512Kbps and 384Kbps.
HD1: corresponds to 1024Kbps and 768Kbps and 512Kbps.
D1: corresponds to 1024Kbps and 768Kbps and 512Kbps.
4) Under AUDIO, select ENABLE or DISABLE. If audio recording is enabled, the system will record audio from
connected audio capable cameras (not included).
5) Under REC. MODE, select POWER UP or TIMER RECORD. If you select POWER UP, the system will record
continuously (Normal Recording) when the system is powered on. If you select TIMER RECORD, you have to
set a recording schedule on the system.
6) Under REC. SIZE, select 15MIN, 30MIN, 45MIN, or 60MIN.
NOTE: Record Size sets the file size for recorded video files on the system. Instead of recording data as one
large file, the system will divide the data into blocks of 15, 30, 45, or 60 minutes. This makes the recorded data
easier to search.
7) Click APPLY. Click CLOSE in the confirmation window.
8) Click EXIT in every menu until all windows are closed.
Recording Schedule
By default, the system is set to record continuously. You can program the system to record according to a customized
recording schedule.
Figure 3.5.16
The Schedule Grid shows the days of the week and hours 0~23. You can set Alarm Recording (Red), General
(Normal) Recording (Green), or No Recording (Blue) to each time block of each day.