Q-See QS434 User manual - Device Operation
DEVICE OPERATION
Model #: QS434
42 |
P a g e
To connect to the DVR from the remote computer you would then open an Internet Explorer browser window and
enter the internet IP of your router that you got by going to
www.myipaddress.com
.
NOTICE: If you cannot use HTTP port 80 because it is being used by another program, or it is being blocked
by your service provider, you can use another port in the same range. If you do so then you need to forward
the IP address of the router to the other port, change the port in the DVR NETWORK settings and you need to
add the port number after the IP address. For example, if you set the HTTP port as 82, you need to enter the IP
address as 192.168.0.25:82.
If you get a error message that says the program cannot load because the publisher is unknown or the program is
unsigned, go to internet explorer, tools, internet options, then go to the “Advanced” tab (RED box in Figure 3.5.52),
this will open the window in Figure 3.5.53, scroll down to “Security”, and select the options to “Allow software to run or
install even if the signature is invalid”, and “Allow Active Content to Run Files on My Computer” (RED box in Figure
3.5.53)
Figure 3.5.52
Figure 3.5.53
NOTICE: If you still have problems connecting remotely:
Anti-virus programs could also block the ActiveX control, if you
still have a problem try closing them. Other plug-ins could also block it. Close firewalls in Windows and in the router if
applicable.
If you have a router plugged into another router, for example, if you have the DVR attached to a router which is
attached to DSL or Cable router, you may need to forward port 80 (or whatever port you are using) on the DSL or
Cable router to the IP address of the router that the DVR is attached to, so that router can then forward the port to
the DVR. Please refer to the PORT FORWARDING section above on how to get instructions on how to forward the
port on the other router.