Q-See QS434 User manual - Device Operation
DEVICE OPERATION
Model #: QS434
11 |
P a g e
Standby Mode
The system can also be put into Standby Mode. Power will remain to the system but will not be recording.
To start/stop Standby mode:
1) Press and hold the POWER button on the front panel or remote control until the prompt closes. The system
enters standby mode.
2) Press and hold the POWER button on the front panel or remote control until the system beeps. The system
will begin powering up.
Password
IMPORTANT!:
By default, passwords are disabled on the system. You do not need to enter a password when
accessing any system menus. However, for security purposes, it is highly recommended to enable passwords on the
system using the Password Menu.
NOTE:
1) If there is no hard drive in DVR, or the DVR cannot read the hard drive, or the hard drive is not formatted, it
will display an
【H】in the video preview interface.
2) You must format the hard drive in the DVR before using. To do so, follow these steps: menu > HDD
management > format. After formatting, the system will restart.
2. SYSTEM LOGIN
To open the Main Menu:
Right-click anywhere onscreen to open the Sub-Menu and select MAIN MENU (mouse only), or press the
MENU/EXIT button on the remote control or front panel of the system.
NOTE: If passwords are enabled on the system, you need to select your Device ID and enter the 6-digit numerical
password to open the Main Menu.
Figure 3.5.1