Racelogic VBOX LITE Hardware & Software Manual - page 26
VIDEO VBOX LITE MANUAL
Page | 26
22 December 2009
Show Split Info on Graph Chart
The start / finish and split lines can be hidden from view by selecting the Show
Split Info on Graph Chart option. This is available either by right-clicking on any
of the three main windows to bring up the context menu, or from the Graph
Setup button on the Toolbar. If you choose to hide the start / finish and split
lines they will still remain active – the software will still save the split lines even if they are not visible.
Gate Width
The width of the split gate can be set from the ‘Start, Finish & Splits’ menu.
If you intend to create a split file in VBOX Tools for use at a circuit, where split
points are placed on areas of track which pass very close to each other, it may be
necessary to reduce the gate width accordingly: this will ensure that you do not
inadvertently drive back through a split point even though you are on a different
section of the track. See the following example.
The circled area circled in green shows two sections of track passing by each
other by only approximately 20m. If a split point is set on this section, and
the virtual gate has been set too wide, the split point could be registered by
the Video VBOX LITE as it passes by in the opposite direction.
Track proximity can be checked in Google Earth
TM
using the measurement
tool if you are in doubt as to how wide the split points should be created.