Racelogic VBOX LITE Hardware & Software Manual - page 9
VIDEO VBOX LITE MANUAL
Page | 9
22 December 2009
6. When a memory card has been inserted, the unit will beep and
the ‘STATUS’ LED will illuminate.
7. Place the vehicle so the antenna has a clear view of the sky, it will
take up to two minutes to acquire satellite lock, at which point
the ‘GPS’ LED will illuminate.
If you are in an open area, and you are still having trouble gaining
lock, press and hold the RECORD button for 10 seconds, this will
perform a ‘cold start’.
8. The default recording mode is ‘record only when moving’. Once satellite lock has been obtained, the unit will
start recording every time the vehicle goes above 2.5km/h and stop when the speed has been less than
2.5km/h for 5 seconds.
9. You can override this setting and toggle the recording by pressing the ‘RECORD’ button. To go back into
‘Record only when moving’ mode, either re-boot the box, or re-insert the SD card.
IMPORTANT
SD Card Removal
NEVER eject the SD card if the ‘RECORD’ LED is showing, you will lose video. To stop recording, either come to
a halt, press the ‘RECORD’ button or disconnect the power (the internal ‘tank circuit’ will stop the recording
and safely shut down the file).
Using the Supplied USB Cable
When connecting the Video VBOX to your computer, make sure you are using the Mini-USB to USB cable
supplied with the unit.
Other leads, for example those supplied with USB card readers, do not have a standard length USB connector
and will completely prevent communication between your PC and the Video VBOX LITE and in some cases
may cause the USB port on your computer to lock up.
Mobile Phone Software
Ensure that you shut down any mobile phone software running on your computer before connecting
your Video VBOX LITE. Racelogic are aware of conflicts which can arise when using this software that
interfere with the normal USB communication between your Video VBOX LITE and the USB port of your
computer.