Xerox Color 1000 User Manual - page 219
5. From the print server, select the job in the Hold queue and then select Job Properties.
The Job Properties window opens.
6. Select the Basic tab.
7. For Paper Stock, select the Loaded Stocks button and select the specific stock that
you loaded.
8. For Sides Imaged, select 2 Sided.
9. Select the Stapling/Finishing menu and select Perfect Bind > Portrait Left.
This setting places the spine on the left side of the book as it faces you.
10. Select Finishing Settings.
The Perfect Binder Settings window opens.
11. Under Units, select either inches or mm for the measurement unit.
12. From the Type, select Pre-printed Cover.
13. For Stock, select the cover stock that you previously loaded into the binder’s cover
inserter tray.
Select it from Loaded Stocks since it was previously loaded in the tray.
14. For cover Position, accept the default values of 0.00 for Center and Side.
15. For Rotation Adjustment, accept the default values of 0.00 for Top, Front and Bottom.
16. In the Trim area of the window, select Full-Bleed.
This trims the three sides of the bound book that are not bound. This selection provides
the best quality output.
17. From the Standard Size drop down menu, select the size you want for the finished
book.
18. For Vertical Position, leave the default value of 0.00.
If you want more trimmed from the bottom and less trimmed at the top, decrease
the setting. If you want more trimmed from the top and less trimmed at the bottom,
increase the setting. The total trim amount remains the same, but the bound book
is shifted up or down during the cutting process.
19. Select OK to save and close.
20. Select Print.
The job is sent to the printer and binder.
21. From the binder, the book stacker tray LED lights indicating that a finished book was
delivered to book stacker tray.
22. Press the button to open the book stacker tray.
23. Remove the book and close the tray.
16-15
Xerox
®
Color 800/1000 Press
User Guide
Perfect Binder