Xerox Color 1000 User Manual - page 327

Paper path

1. The booklet leaves the booklet area of the finisher and enters SquareFold Trimmer

Module.

2. The Booklet Exit sensor (in the SquareFold Trimmer Module) detects the lead edge

(spine) of booklet and moves the booklet to square fold area.

3. Once the booklet spine reaches the square fold area, the booklet is clamped and the

square-folding operation begins.

4. The booklet is flattened and the spine squared according to the square-fold setting

indicated on the control panel.

5. After the booklet is flattened and the spine squared, it is moved to the trimmer area.

a. Based on the finished booklet size, the booklet is moved until the trail edge reaches

the trimmer cutter.

b. The trail edge is trimmed/cut (based on the finished booklet size entered for the

Trimmer Mode Setting).

6. The booklet then moves to the exit area where it is transported to the Booklet Output

Tray.

Note

Booklets exiting/leaving the SquareFold Trimmer Module may contain trim

remnants/scraps from the previously trimmed booklet. This is due to static electricity

build-up and is normal. If booklets contain trim remnants/scraps, simply remove and

discard them.

18-3

Xerox

®

 Color 800/1000 Press

User Guide

SquareFold Trimmer Module