Yamaha 2004 FZ6-SS Service Manual - Chas
4-7
FRONT WHEEL AND BRAKE DISCS
CHAS
NOTE:
72 Nm (7.2 m
Skg, 52 ftSlb)
23 Nm (2.3 m
Skg, 17 ftSlb)
CAUTION:
40 Nm (4.0 m
Skg, 29 ftSlb)
NOTE:
10 Nm (1.0 m
Skg, 7.2 ftSlb)
WARNING
NOTE:
NOTE:
3. Insert the wheel axle.
Install the tire and wheel with the mark
1
point-
ing in the direction of wheel rotation.
4. Lower the front wheel so that it is on the
ground.
5. Tighten:
Swheel axle
Swheel axle pinch bolt
Before tightening the wheel axle pinch bolt,
push down hard in the handlebar several
times and check if the front fork rebounds
smoothly.
6. Install:
Sbrake calipers (left and right)
Make sure that there is enough space between
the brake pads before installing the brake cali-
pers onto the brake discs.
7. Install:
Sbrake hose holder
Make sure the brake hose is routed properly.
EAS00549
ADJUSTING THE FRONT WHEEL STATIC
BALANCE
SAfter replacing the tire, wheel or both, the front
wheel static balance should be adjusted.
SAdjust the front wheel static balance with the
brake discs installed.
1. Remove:
Sbalancing weight(s)
2. Find:
Sfront wheel’s heavy spot
Place the front wheel on a suitable balancing
stand.