Yamaha 2004 FZ6-SS Service Manual - Eng
5-80
CONNECTING RODS AND PISTONS
ENG
NOTE:
NOTE:
INSTALLING THE CONNECTING ROD AND
PISTON (except for CAL)
The following procedure applies to all of the
connecting rods and pistons.
1. Install:
Stop ring
1
S2nd ring
2
Supper oil ring rail
3
Soil ring expander
4
Slower oil ring rail
5
Be sure to install the piston rings so that the
manufacturer’s marks or numbers
a
face up.
2. Install:
Spiston
1
(onto the respective connecting rod
2
)
Spiston pin
3
Spiston pin clip
New
4
SApply engine oil onto the piston pin.
SMake sure that the “Y” mark
a
on the connect-
ing rod faces left when the arrow mark
b
on
the piston is pointing up. Refer to the illustra-
tion.
SReinstall each piston into its original cylinder
(numbering order starting from the left: #1 to
#4).
3. Lubricate:
Spiston
Spiston rings
Scylinder
(with the recommended lubricant)
Recommended lubricant
Engine oil