Yamaha 2004 FZ6-SS Service Manual - Gen

1-7

IMPORTANT INFORMATION

GEN

INFO

CAUTION:

EAS00023

LOCK WASHERS/ PLATES AND COTTER

PINS

After removal, replace all lock washers / plates

1

 and cotter pins. After the bolt or nut has been

tightened to specification, bend the lock tabs

along a flat of the bolt or nut.

EAS00024

BEARINGS AND OIL SEALS

Install bearings and oil seals so that the

manufacturer’s marks or numbers are visible.

When installing oil seals, lubricate the oil seal

lips with a light coat of lithium-soap-based

grease. Oil bearings liberally when installing, if

appropriate.

1

Oil seal

Do not spin the bearing with compressed air

because this will damage the bearing sur-

faces.

1

Bearing

EAS00025

CIRCLIPS

Before reassembly, check all circlips carefully

and replace damaged or distorted circlips. Al-

ways replace piston pin clips after one use.

When installing a circlip 

1

, make sure the

sharp-edged corner 

2

 is positioned opposite

the thrust 

3

 that the circlip receives.

4

Shaft