Yamaha 2004 FZ6-SS Service Manual - Chas
4-58
HANDLEBAR
CHAS
26 Nm (2.6 m
Skg, 19 ftSlb)
NOTE:
NOTE:
26 Nm (2.6 m
Skg, 19 ftSlb)
WARNING
5. Install:
Sgrip end
6. Adjust:
Sthrottle cable free play
Refer to “ADJUSTING THE THROTTLE
CABLE FREE PLAY” in chapter 3.
Throttle cable free play (at the
flange of the throttle grip)
3
X 5 mm (0.12 X 0.20 in)
7. Install:
Sclutch lever holder
1
Sclutch cable
Align the slit on the clutch lever holder with the
punch mark
a
on the handlebar.
8. Adjust:
Sclutch cable free play
Refer to “ADJUST THE CLUTCH CABLE
FREE PLAY” in chapter 3.
Clutch cable free play (at the end
of the clutch lever)
10
X 15 mm (0.39 X 0.59 in)
9. Install:
Sleft handlebar switch
Align the projection
a
on the left handlebar
switch with the hole
b
on the handlebar.
10. Install:
Shandlebar grip
Sgrip end
a. Apply a thin coat of rubber adhesive onto the
left end of the handlebar.
b. Slide the handlebar grip over the left end of
the handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
Do not touch the handlebar grip until the
rubber adhesive has fully dried.