Yamaha 2004 FZ6-SS Service Manual - page 354
7-18
FUEL INJECTION SYSTEM
FI
Tester positive prove
! blue
Tester negative prove
! yellow/green
1
2
Fault code No.
30
Symptom
The motorcycle has overturned.
Used diagnostic code No. 08 (lean angle cut-off switch)
Order
Inspection operation item and probable
cause
Operation item and countermeasure
Reinstatement
method
1
The motorcycle has overturned.
Raise the motorcycle upright.
Reinstated by
2
Installed condition of the lean angle cut-
off switch
Check the installed area for looseness or
pinching.
turning the
main switch
ON (however
3
Connected condition of connector
Inspect the coupler for any pins that
may have pulled out.
Check the locking condition of the
coupler.
If there is a malfunction, repair it and connect it
securely.
Lean angle cut-off switch coupler
Main wiring harness ECU coupler
ON (however,
the engine can-
not be re-
started unless
the main switch
is first turned
4
Defective lean angle cut-off switch
Execute the diagnostic mode (code No. 08)
Replace if defective.
1. Remove the lean angle cut-off switch from the
motorcycle.
2. Connect the lean angle cut-off switch coupler
to the wireharness.
3. Connect the pocket tester (DC 20 V) to the
lean angle cut-off switch coupler as shown.
4. When turning the lean angle cut-off switch
approx. 65
_, the voltage reading change from
1.0 V to 4.0 V.
5. Is the emergency stop switch OK?
is first turned
OFF).