Yamaha 2004 FZ6-SS Service Manual - Chas
4-57
HANDLEBAR
CHAS
WARNING
23 Nm (2.3 m
Skg, 17 ftSlb)
CAUTION:
NOTE:
NOTE:
NOTE:
EAS00672
INSTALLING THE HANDLEBAR
1. Stand the motorcycle on a level surface.
Securely support the motorcycle so that
there is no danger of it falling over.
2. Install:
Shandlebar
1
Supper handlebar holders
2
Supper handlebar holder caps
3
SFirst, tighten the bolts on the front side of
the handlebar holder, and then on the rear
side.
STurn the handlebar all the way to the left
and right. If there is any contact with the
fuel tank, adjust the handlebar position.
Align the match marks
a
on the handlebar with
the upper surface of the lower handlebar hold-
ers.
3. Install:
Sthrottle cables
Sright handlebar switch
1
Sthrottle grip
2
Align the projections
a
on the handlebar switch
with the holes
b
in the handlebar.
4. Install:
Sfront brake master cylinder
1
Sfront brake master cylinder holder
2
Refer to “ASSEMBLING AND INSTALLING
THE FRONT BRAKE MASTER CYL-
INDER”.
SThere should be 17 mm (0.67 in) of clearance
between the right handlebar switch and front
brake master cylinder.
SAlign the mating surfaces of the master cylin-
der bracket with the punch mark (right handle-
bar switch side)
a
on the handlebar.