Yamaha 2004 FZ6-SS Service Manual - page 342
7-6
Engine operation is not normal or the engine trouble warning light is on.
* Engine trouble warning light may not come on even if the engine operation is not normal.
The engine trouble warning light comes on.
Check the fault code number displayed on the me-
ter.
Identify the system with the malfunction. (Refer to
the “FAIL-SAFE ACTIONS TABLE”.)
Identify the probable cause of malfunction. (Refer
to the “Fault code table”.)
Check and repair the probable case of malfunc-
tion.
Fault code No. YES
Fault code No. NO
Check and repair.
(Refer to “TROU-
BLESHOOTING DE-
TAILS”.)
Monitor the operation
of the sensors and
actuators in the diag-
nostic mode. (Refer
to “Diagnostic mode
table” in chapter 7)
Check and repair.
(Refer to “TROU-
BLESHOOTING DE-
TAILS”.)
Perform ECU reinstatement action. (Refer to “Re-
instatement method” in “TROUBLESHOOTING
DETAILS”.)
Turn the main switch to “OFF”, turn the main switch
back to “ON”, and then check if the fault code num-
ber is still displayed.
Erasing the malfunction history:*
The malfunction history is stored even if the main
switch is turned OFF.
The malfunction history must be erased in the
diagnostic mode. (Refer to the “Diagnostic mode
table (Diagnostic code No.62)”)
Repairs completed
The engine trouble warning light does not come
on.
Check the operation of following sensors and ac-
tuators in the diagnostic mode (Refer to “Diagnos-
tic mode table” in chapter 7.)
01: Throttle position sensor (throttle angle)
30: Ignition coil #1, #4
31: Ignition coil #2, #3
36: Injector #1, #4
37: Injector #2, #3
48: Al system solenoid
Malfunction of en-
gine
Defective sensor
or actuator
Check and repair
the inner parts of
engine. (Refer to
Chapter 5)
Check and repair
the corresponding
sensor or actua-
tor.
* Operated when the engine trouble warning light is on.
Fault code
number displayed
Fault code number not displayed
OK
NG
OK
OK
Check the engine condition.
OK
NG
FUEL INJECTION SYSTEM
FI
EAS00904
TROUBLESHOOTING CHART