Yamaha 2004 FZ6-SS Service Manual - Spec

2-42

X Make sure to pass the neutral switch lead through

the hole of the flap.

Y Clamp the seat lock wire to the frame as shown in

the illustration. Secure the clamp to the weld of the

cross member with the frame. Position the binding

section in front of the vehicle body and cut the tip to

be between 1 and 5 mm (0.04 and 0.20 in).

R To the rear turn signal light (left)

S Pass the fuel tank drain hose through the clamp lo-

cated under the coolant reservoir tank.

T Route it behind the starter motor lead.

U Point the bend-R section of the throttle cable (pull

side) to the inner side horizontally. It is also possible

to visually check the bend-R section.

V To the headlight lead.

W Point the tip of the clamp to the inner side of the ve-

hicle body.

CABLE ROUTING

SPEC