Yamaha BLASTER YFS200S Owner's Manual - page 122

9. Remove the float by removing the pin.

10. Remove the needle valve by unhooking it

from the float arm.

11. Change the main jet and the jet needle clip

position. (See page 8-16.)

1. Float

2. Pin

3. Needle valve

4. Float arm

5. Main jet

NOTE:

An optional main jet can be obtained at a

Yamaha dealer.

Assembling the carburetor

1. Install the needle valve by hooking it onto

the float arm.

2. Install the float by inserting the pin into the

holder.

3. Install the float chamber by installing the

screws.

4. Connect the throttle cable onto the throttle

valve by installing the holder and the

screws.

1

2

3

4

5

8-19

 5VM-9-11_4  3/11/03 1:11 PM  Page 20