Yamaha BLASTER YFS200S Owner's Manual - page 136
Other manuals for BLASTER YFS200S:
Owner's Manual
of
168
1. Locknut
2. Chain adjuster
3. Alignment marks
3. After adjusting, be sure to tighten the lock-
nuts and the wheel hub bolts.
EBU00805
Lubricating the drive chain
The drive chain must be cleaned and lubricated
at the intervals specified in the periodic mainte-
nance and lubrication chart, otherwise it will
quickly wear out, especially when riding in dusty
or wet areas. Service the drive chain as follows.
c
C
The drive chain must be lubricated after
washing the ATV or riding in the rain.
1. Clean the drive chain with kerosene and a
small soft brush.
Upper wheel hub bolt:
50 Nm (5.0 m
0kgf, 36 ft0lbf)
Lower wheel hub bolt:
50 Nm (5.0 m
0kgf, 36 ft0lbf)
e
q
w
q
w
8-33
5VM-9-11_4 3/11/03 1:11 PM Page 34