Yamaha BLASTER YFS200S Owner's Manual - page 25

EBU00053

Handlebar switches

EBU01158

Engine stop switch “ENG. STOP”

Make sure that the engine stop switch is in the

“RUN” position before starting the engine. The

engine stop switch controls ignition and can be

used at all times to stop the engine, especially in

an emergency. The engine will not start or run

when the engine stop switch is turned to “OFF”.

EBU01286

Light switch “LIGHTS”

Set the switch to the “LO” position to switch on

the low beam and the taillight.

Set the switch to the “HI” position to switch on

the high beam and the taillight.

Set the switch to the “OFF” position to switch off

all the lights.

NOTE:

The headlight and the taillight can be turned on

only when the engine is started.

4-3

q

w

1. Light switch “LIGHTS”

2. Engine stop switch “ENG. STOP”

 5VM-9-11_1  3/11/03 1:08 PM  Page 4-3