Yamaha BLASTER YFS200S Owner's Manual - page 132
Other manuals for BLASTER YFS200S:
Owner's Manual
of
168
NOTE
If the cable cannot be adjusted to specification,
consult a Yamaha dealer.
4. Tighten the locknut at the clutch lever.
5. Screw in the adjusting bolt at the rear
brake caliper by hand until it feels tight,
then screw it out 1/8 turn. Tighten the lock-
nut to the specified torque.
1. Adjusting bolt
2. Locknut
c
C
When tightening the locknut, hold the adjust-
ing bolt with a wrench so that the adjusting
bolt does not turn together with the locknut.
8-29
Tightening torque:
Locknut:
16 Nm (1.6 m
0kgf, 11 ft0lbf)
q
w
5VM-9-11_4 3/11/03 1:11 PM Page 30