Can-Am 2009 Outlander 500 EFI Operator's Manual - Lights
MAINTENANCE PROCEDURES
Lights
WARNING
Always turn the ignition switch to
OFF position before replacing a de-
fective bulb.
Always check light operation after re-
placement.
Headlight Bulb Replacement
NOTICE
Never touch glass por-
tion of a halogen bulb with bare fin-
gers, it shortens its operating life. If
glass is touched, clean it with iso-
propyl alcohol which will not leave a
film on the bulb.
NOTE:
On the following illustration,
the headlight has been removed for a
better comprehension.
To replace the headlight bulb, proceed
as follows:
Remove cover screws.
vmo2006-005-043_a
1. Screws
2. Holder
Remove rubber protector from head-
light housing.
vmo2006-005-040_a
1. Rubber protector
2. Headlight housing
Unplug connector from headlight.
NOTE:
Press small locking tab to un-
lock connector then pull on connector.
vmo2006-005-041_a
PUSH ON LOCKING TAB TO UNLOCK
CONNECTOR
NOTE:
Concerning the following il-
lustrations, the front fascia has been
removed from the vehicle for a better
comprehension.
Press the spindle then push it on the
side to unlock headlight bulb.
______________
101