Can-Am 2009 Outlander 500 EFI Operator's Manual - 8) 12-Volt Power Outlet
CONTROLS/INSTRUMENTS/EQUIPMENT
Indicator Lamps
NOTE:
Use in conjunction with
DIS-
PLAY 3 (MODE/MESSAGE) MES-
SAGES TABLE
for additional informa-
tion regarding messages.
vmo2008-001-020_k
1. Parking brake indicator lamp
2. 4WD indicator lamp
3. Low fuel level indicator lamp
4. Check engine indicator lamp
5. High beam indicator lamp
Description:
Parking brake is activated.
4WD system is activated.
Low fuel level. There is only
30% of fuel left in fuel tank, ap-
proximately 6 L (1.6 U.S. gal).
Check engine/DESS system op-
eration.
High headlight beam position
selected.
8) 12-Volt Power Outlet
Convenient for handheld spotlight or
other portable equipment.
Remove protective cap to use. Always
reinstall it after use to protect against
weather.
Do not exceed the rating capacity. See
SPECIFICATIONS
.
An auxiliary supply is available to con-
nect additional accessories. Two wires
are hidden in the wiring harness at
the front of vehicle underneath dash
board. See an authorized Can-Am deal-
er for more details.
9) Ignition Switch
Key-operated 3-position switch.
vmo2006-016-002_a
IGNITION SWITCH POSITIONS
1. OFF
2. ON "with light"
3. ON "without light"
Insert key in switch and turn to the de-
sired position. To remove key, turn key
to OFF position then pull it out.
NOTE:
When turning the key to OFF
position and removing the key, the ve-
hicle electrical system will take a few
seconds to shut down.
66
______________