Can-Am 2009 Outlander 500 EFI Operator's Manual - Warning
MAINTENANCE PROCEDURES
WARNING
Never run engine in an enclosed
area. Never perform this opera-
tion immediately after the engine
has been run because exhaust sys-
tem is very hot. Make sure that
there are no combustible mate-
rials in the area. Wear eye pro-
tection and gloves. Never stand
behind the vehicle while purging
exhaust system. Respect all appli-
cable laws and regulations.
Select a well-ventilated area and make
sure the muffler is cool.
Place transmission on PARK position.
Remove the clean out plug of the muf-
fler.
vmo2006-007-024_a
TYPICAL
1. Clean out plug
2. Muffler
Block the end of the muffler with a
shop rag and start engine.
Momentarily increase engine RPM
several times to purge accumulated
carbon out of the muffler.
Stop engine and allow muffler to cool.
Reinstall the clean out plug.
CVT Air Filter
800R Models
CVT Air Filter Removal
1. Remove seat from vehicle.
2. Release central panel tabs from
frame.
3. Remove central panel by pulling it
towards the rear of vehicle.
vmo2006-007-026_a
1. Central panel
2. Tabs
4. Locate access cover on LH side of
vehicle underneath front fender.
5. Remove plastic darts that hold ac-
cess cover.
6. Remove access cover.
vsi2008-023-001_a
ACCESS COVER
1. Plastic darts
92
______________