Can-Am 2009 Outlander 500 EFI Operator's Manual - Brake
MAINTENANCE PROCEDURES
Front Suspension Inspection
Inspect the McPherson struts or shock
absorber for oil leaks or other dam-
ages.
Check tightness of fasteners.
See an authorized Can-Am dealer as
necessary.
A-Arms
Check A-arms for cracks, bending or
other damages.
See an authorized Can-Am dealer as
necessary.
Rear Suspension Inspection
Inspect the shock absorbers for oil
leaks or other damages.
Check tightness of fasteners.
See an authorized Can-Am dealer as
necessary.
Trailing Arms
Check trailing arms for distortion,
cracks or bending.
See an authorized Can-Am dealer if any
problem is detected.
Brake
Brake Fluid
Brake Fluid Level
With vehicle on a level surface, check
brake fluid in reservoirs for proper lev-
el. They should be above MIN. mark.
Add fluid as required.
Do not overfill.
Clean filler cap before removing.
NOTICE
Use only DOT 4 brake flu-
id from a sealed container. Do not
use brake fluid taken from old or al-
ready opened containers.
NOTE:
A low level may indicate leaks
or worn brake pads. See an authorized
Can-Am dealer.
Brake Lever Fluid Reservoir
Turn steering in the straight-ahead po-
sition to ensure reservoir is level.
Check the brake fluid level, the reser-
voir is full when the fluid reaches of the
top of window.
Visually inspect lever boot condition.
Check for cracks, tears, etc. Replace if
damaged.
vmo2006-016-004_a
TYPICAL
Brake Pedal Fluid Reservoir
Remove front service compartment
panel.
To open the front service compartment
panel, unlatch then lift.
Remove it completely from vehicle.
With vehicle on a level surface, liquid
should be between MIN. and MAX.
level marks of brake pedal fluid reser-
voir.
106
______________