Can-Am 2009 Outlander 500 EFI Operator's Manual - page 128
MULTIFUNCTION GAUGE MESSAGES
NOTE:
For any fault code not listed in the following table, refer to an authorized
Can-Am dealer.
MESSAGE
PILOT LAMP(S) ON
DESCRIPTION
INVALID KEY
Check engine
Indicates that you have used the wrong
ignition key, use the proper key for this
vehicle.
It is also possible that the ignition key
has a bad contact, remove and clean
key.
PARK BRAKE
Parking brake
Is displayed when parking brake is ap-
plied for more than 15 seconds (while
riding).
LO BATT
Check engine
Low battery voltage, check battery volt-
age and charging system.
HI BATT
Check engine
High battery voltage, check battery volt-
age and charging system.
LOW OIL
(1)
Check engine
Engine low oil pressure, stop engine im-
mediately.
HI TEMP
Check engine
Engine is overheating, refer to
ENGINE
OVERHEATS
in
TROUBLESHOOTING
.
LIMP HOME
Check engine
Serious fault on the engine that can
change the normal operation of the en-
gine, CHECK ENGINE indicator lamp will
also blink. See an authorized Can-Am
dealer.
CHECK ENGINE
Check engine
Engine fault, CHECK ENGINE indicator
lamp will also be ON. See an authorized
Can-Am dealer.
MAINTENANCE
SOON
(2)
Check engine
Periodic maintenance required. See an
authorized Can-Am dealer.
NO ECM
COMMUNICATION
Check engine
Communication error between mul-
tifunction gauge and engine control
module (ECM), contact an authorized
Can-Am dealer.
NOTICE
(1)
If the message LOW OIL and the check engine light do not turn off
right after engine starting, stop engine. Check engine oil level. Refill if neces-
sary. If the oil level is good, see an authorized Can-Am dealer. Do not use the
vehicle until repaired.
(2)
Message must be erased by an authorized Can-Am dealer.
126
______________