Can-Am 2009 Outlander 500 EFI Operator's Manual - Warning
MAINTENANCE PROCEDURES
vmo2006-007-017_a
BRAKE PEDAL FLUID RESERVOIR
Recommended Brake Fluid
Always use brake fluid meeting the
specification DOT 4 only.
NOTICE
To avoid serious damage
to the braking system, do not use
fluids other than the recommended
one, nor mix different fluids for top-
ping up.
Brake Inspection
The braking system is a hydraulic type
and no adjustment is required.
Check the following to keep the brakes
in a good operating condition:
– Brake fluid level
– Brake system for fluid leaks
– Brake for spongy feel
– Brake cleanliness
– Brake discs for excessive wear and
surface condition
– Brake pads for wear, damage or
looseness.
SERVICE LIMITS
Brake pads
thickness
1 mm (.040 in)
Front discs
thickness
3.5 mm (.138 in)
Rear disc thickness
4.3 mm (.170 in)
Maximum discs
warpage
0.2 mm (.010 in)
See your authorized Can-Am dealer if
a problem is detected concerning the
brake system.
WARNING
The brake fluid replacement or
brake system maintenance and
repairs should be performed by an
authorized Can-Am dealer.
Body
Storage Cover Latches
Check that front service compartment
cover and rear storage compartment
cover are properly latched and that
latches are in good condition.
Seat Fasteners
Remove seat(s) and/or storage box and
check latch mechanisms and pins for
wear. See an authorized Can-Am deal-
er for parts replacement if damaged.
Vehicle Cleaning and Protection
Never use a high pressure washer to
clean the vehicle.
USE LOW PRES-
SURE ONLY (like a garden hose).
High pressure can cause electrical or
mechanical damages.
Painted parts which are damaged
should be properly repainted to pre-
vent rust.
______________
107