Can-Am 2009 Outlander 500 EFI Operator's Manual - Warning
MAINTENANCE PROCEDURES
Wheel Removal/Installation
Loosen nuts then lift vehicle.
Place a support under vehicle.
Remove nuts then remove wheel.
At installation, it is recommended to
apply anti-seize lubricant on threads.
Gently tighten nuts in a criss-cross se-
quence then apply final torque.
TORQUE APPLICATION
STANDARD MODELS
70 N•m (52 lbf•ft)
XT MODELS
100 N•m (74 lbf•ft)
CAMO XT MODELS
70 N•m (52 lbf•ft)
NOTE:
Occasionally,
wheel
nuts
should be removed to apply anti-seize
lubricant on studs to ease future re-
moval. This is particularly important
when vehicle is used in salt-water en-
vironment or in mud. Remove one nut
at a time, lubricate then retorque.
1
V07H04Y
TYPICAL — OPENED END TYPE
1. Taper side of nut
NOTICE
Always use the recom-
mended wheel nuts (P/N 250 100
096). Using a different nut could
cause damages to the rim.
vmo2008-001-002_a
TYPICAL — CLOSED END TYPE
1. Wheel nut
While reading this Operator’s Guide, reminder that:
WARNING
Indicates a potential hazard that, if not avoided, could result in serious
injury or death.
104
______________