Can-Am DS250 Operator's Manual - page 79
MAINTENANCE CHART
PERIODIC MAINTENANCE CHART
INITIAL INSPECTION 10 H OR 30 DAYS OR 200 KM (125 mi)
(To be performed by an authorized Can-Am dealer. The initial
maintenance is very important and must not be neglected.)
25 H OR 500 km (310 mi)
50 H OR 1000 km (620 mi)
100 H OR 1 YEAR OR 2000 km (1250 mi)
200 H OR 2 YEARS OR 4000 km (2485 mi)
A: ADJUST
C: CLEAN
I: INSPECT
L: LUBRICATE
R: REPLACE
T: PROCEED WITH TASK
TO BE PERFORMED BY
PART/TASK
LEGEND
BODY/FRAME
Frame
I
Dealer
Hitch/trailer ball condition (if installed)
EVERY RIDE
Customer
Frame fasteners
I
Customer
Seat fasteners
EVERY RIDE
Customer
Engine and vehicle cleaning and
protection
EVERY RIDE
Customer
—
The vehicle maintenance should be performed by an authorized Can-Am dealer. If
you have the necessary mechanical skills and the required tools, you can perform
the procedures outlined in this section.
WARNING
Unless otherwise specified, engine should not be running for all mainte-
nance procedures.
Before performing any service or inspection operation on the vehicle, wait
until the engine and exhaust have cooled down to avoid potential burns.
WARNING
Should removal of a locking device (e.g. lock tabs, self-locking fasteners,
etc.) be required when undergoing disassembly/assembly, always replace
with a new one.
_____________________
77