Can-Am DS250 Operator's Manual - page 92
FUEL SYSTEM
Throttle Cable
Throttle Cable Lubrication
The throttle cable must be lubricated
with silicone cable lubricant (P/N 293
600 041) or an equivalent.
WARNING
Always use a silicone-based lu-
bricant. Using another lubricant
(like water-based lubricant) could
cause the throttle lever/cable stick-
ing or stiffness.
Open the throttle lever housing.
vmo2006-014-051_a
1. Remove screws
Slide the rubber protector to expose
the cable adjuster.
Unscrew the lock nut of the cable ad-
juster then screw in the adjuster to
release the cable tension.
vmo2006-014-051_b
1. Rubber protector
2. Cable adjuster
Remove the cable from the throttle
lever.
NOTE: Slide cable in clip slot and re-
move the end of cable from clip.
Remove the carburetor cap on top of
the carburetor. Place the carburetor
cap far from carburetor body.
Install the cable luber (P/N 529 035
738) on the cable.
Insert the needle of spray can in the ca-
ble luber hole.
WARNING
Always wear eye protection and
gloves when you lubricate a cable.
NOTE: Place a rag around the cable lu-
ber to prevent the lubricant splash.
Add lubricant until it runs out at carbu-
retor end of the throttle cable.
Let the cable hang during approximate-
ly 15 minutes or until no lubricant flows
out of cable.
Reinstall carburetor cap.
Reinstall and adjust the cable.
90
______________________