Can-Am DS250 Operator's Manual - page 98
DRIVE SYSTEM
Drive Chain
Adjust and lubricate drive chain before
each use.
WARNING
Place ignition switch to the OFF
position before checking, adjust-
ing or lubricating the drive chain.
NOTICE
Never operate this vehi-
cle with the drive chain too loose or
too tight as severe damage to the
drive components can occur.
Drive chain Inspection
This vehicle is equipped with O-ring
sealed permanently greased pins and
rollers. Before operating the vehicle,
always inspect the drive chain.
Check the free play of drive chain and
adjust if necessary.
Check for damage or missing O-ring or
rollers.
Drive chain Cleaning and
Lubrication
NOTICE
Never wash the chain
with a high pressure washer or gaso-
line. Damage to the O-ring will re-
sult, causing premature wear and
drive chain failure.
Clean the side surfaces of the chain
with a dry cloth.
NOTE: Do not brush chain.
Lubricate only with an approved O-ring
chain lubricant.
Other commercial
chain lubricants may contain solvent
which could damage the O-rings.
Drive chain Adjustment
NOTE: Adjust drive chain with the driv-
er seated on the vehicle.
Select a level surface and set transmis-
sion to NEUTRAL.
Loosen chain tensioner lock bolts and
caliper support bolt.
vmo2006-014-048_a
TYPICAL
1. Chain tensioner lock bolts
vmo2006-014-059_a
1. Caliper support bolt
Insert adjuster lock through sprocket
hub and into chain tensioner.
96
______________________