Can-Am DS250 Operator's Manual - page 84
ENGINE
Properly tighten dipstick.
Engine Oil Change and Oil Strainer
Cleaning
Oil change should be done with a warm
engine.
WARNING
The engine oil can be very hot. In
order to avoid potential burns, do
not remove the engine drain plug
or the oil strainer cover if the en-
gine is hot. Wait until engine oil is
warm.
Ensure vehicle is on a level surface.
Remove dipstick.
Clean the drain plug area.
Place a drain pan under the engine
drain plug area.
Unscrew drain plug.
vmo2006-014-035_a
LH SIDE UNDERNEATH CVT COVER
1. Oil drain plug
Unscrew the oil strainer cover.
Allow enough time for oil to flow out of
oil strainer hole.
vmo2006-014-036_a
RH SIDE OF ENGINE
1. Oil strainer cover
Remove oil strainer and spring.
To clean oil strainer, use a solvent then
dry with compressed air.
WARNING
Always wear eye protector. Chem-
icals can cause a rash break out
and an injury to your eyes.
NOTE: Check cover O-ring and replace
it if necessary.
Wipe out any oil spillage on engine.
vmo2006-014-037_a
1. Cover
2. O-ring
3. Spring
4. Strainer
Reinstall oil strainer, spring, O-ring and
torque cover to 15 N•m (133 lbf•in).
Verify drain plug washer condition and
replace it if necessary.
82
______________________