Can-Am DS250 Operator's Manual - page 96
ELECTRICAL SYSTEM
Headlights Bulb Replacement
NOTICE
Never touch glass portion
of an halogen bulb with bare fingers,
it shortens its operating life. If glass
is touched, clean it with isopropyl al-
cohol which will not leave a film on
the bulb.
NOTE: Concerning the following il-
lustrations, the headlight housing has
been removed from the vehicle for a
better comprehension.
To replace the headlight bulb, proceed
as follows.
Remove rubber protector over head-
light housing.
vmo2009-002-001_a
TYPICAL
1. Rubber protector
Unplug connector from headlight.
Push the retaining clip round ends for-
ward then set them on the sides to un-
lock headlight bulb.
vmo2008-018-036_a
TYPICAL
1. Retaining clip
Lift and hold the retaining clip then re-
move the bulb.
vmo2008-018-037
TYPICAL
Replace bulb.
Properly reinstall removed parts in the
reverse order of their removal.
Taillight Bulb Replacement
Unscrew lens screws to expose bulb.
94
______________________