Can-Am DS250 Operator's Manual - page 94
ELECTRICAL SYSTEM
WARNING
Unless otherwise informed, al-
ways turn ignition switch to the
OFF position before performing
any maintenance or repair on elec-
trical system.
Spark Plug
Spark Plug Removal
Unplug spark plug cable.
Unscrew spark plug one turn.
Clean spark plug and cylinder head
with pressurized air if possible.
WARNING
Always wear safety goggles when
using pressurized air.
Unscrew spark plug completely then
remove them.
vmo2006-014-066_a
LH SIDE OF ENGINE
1. Spark plug
Spark Plug Installation
Prior to installation make sure that con-
tact surface of cylinder head and spark
plug is free of grime.
Using a feeler gauge, set the spark plug
gap to 0.8 mm (0.31 in).
Apply anti-seize lubricant over spark
plug threads to prevent a possible
seizure.
Screw spark plug into cylinder head by
hand and tighten with a torque wrench
and a proper socket.
Torque
spark
plugs
to
11
N•m
(97 lbf•in).
Battery
WARNING
Never charge a battery while in-
stalled in vehicle.
These vehicles are equipped with a
VRLA battery (Valve Regulated Lead
Acid). It is a maintenance-free type
battery, there is no need to add water
to adjust electrolyte level.
NOTICE
Never remove the battery
sealing cap.
Battery Removal
Disconnect BLACK (-) cable first then
RED (+) cable.
WARNING
Always respect this order for dis-
assembly; disconnect BLACK (-)
cable first.
Remove the holding strap.
Remove battery from vehicle.
Battery Cleaning
Clean battery, battery casing, cables
and battery posts using a solution of
baking soda and water.
92
______________________