D-Link DES-3828 - xStack Switch - Stackable User Manual - Ospf Interface Settings
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
134
drop-down menu and determine the Stub Default Cost. Click the Add/Modify button to add the area
ID set to the table.
To remove an Area ID configuration set, simply click
in the Deletecolumn for the configuration.
To change an existing set in the list, type the Area ID of the set you want to change, make the changes
and click the Add/Modify button. The modified OSPF area ID will appear in the table.
Figure 8- 29. OSPF Area Settings example window
See the parameter descriptions below for information on the OSPF Area ID Settings.
The Area ID settings are as follows:
Parameter
Description
Area ID
A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies
the OSPF area in the OSPF domain.
Type
This field can be toggled between Normal and Stub using the space bar. When it is
toggled to Stub, additional fields appear
− Stub Import Summary LSA, and the Stub
Default Cost.
Stub Import
Summary LSA
Displays whether or not the selected Area will allow Summary Link-State
Advertisements (Summary LSAs) to be imported into the area from other areas.
Stub Default Cost
Displays the default cost for the route to the stub of between 0 and 65,535. The default
is 1.
OSPF Interface Settings
To set up OSPF interfaces, click Layer 3 Features > OSPF > OSPF Interface Settings to view
OSPF settings for existing IP interfaces. If there are no IP interfaces configured (besides the default
System interface), only the System interface settings will appear listed. To change settings for in IP
interface, click on the hyperlinked name of the interface to see the configuration menu for that
interface.