D-Link DES-3828 - xStack Switch - Stackable User Manual - Ospf Host Route Settings
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
140
Use the following parameters to configure the following settings for OSPF Area Aggregation:
Parameter
Description
Area ID
Allows the entry the OSPF Area ID for which the routing information will be
aggregated. This Area ID must be previously defined on the Switch.
Network Number
Sometimes called the Network Address. The 32-bit number in the form of an IP
address that uniquely identifies the network that corresponds to the OSPF Area
above.
Network Mask
The corresponding network mask for the Network Number specified above.
LSDB Type
Specifies the type of address aggregation, which is set at Summary.
Advertisement
Select Enabled or Disabled to determine whether the selected OSPF Area will
advertise it’s summary LSDB (Network-Number and Network-Mask).
Click Apply to implement changes made.
OSPF Host Route Settings
OSPF host routes work in a way analogous to RIP, only this is used to share OSPF information with
other OSPF routers. This is used to work around problems that might prevent OSPF information
sharing between routers. To configure OSPF host routes, click the OSPF Host Route Settings link.
To add a new OSPF Route, click the Add button. Configure the setting in the menu that appears. The
Add and Modify menus for OSPF host route setting are nearly identical. The difference being that if
you are changing an existing configuration you will be unable to change the Host Address. To change
an existing configuration, click on the hyperlinked Host Address in the list for the configuration you
want to change and proceed to change the metric or area ID. To eliminate an existing configuration,
click the
in the Delete column for the configuration being removed.
Figure 8- 37. OSPF Host Route Settings table
Use the menus below to add or edit OSPF host routes.