D-Link DES-3828 - xStack Switch - Stackable User Manual - Sntp Settings
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
47
SNTP Settings
Time Settings
To configure the time settings for the Switch, open the Administration folder. Then the SNTP
Settings folder and click on the Time Settings link, revealing the following window for the user to
configure.
Figure 6- 14. Current Time: Status window
The following parameters can be set or are displayed:
Parameter Description
Current Time: Status
System Boot Time
Displays the time when the Switch was initially started for this session.
Current Time
Displays the Current Time.
Time Source
Displays the time source for the system.
Current Time: SNTP Settings
SNTP State
Use this pull-down menu to Enabled or Disabled SNTP.
SNTP Primary Server This is the IP address of the primary server the SNTP information will be taken from.
SNTP Secondary
Server
This is the IP address of the secondary server the SNTP information will be taken
from.