D-Link DES-3828 - xStack Switch - Stackable User Manual - User Accounts
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
41
The PoE Configuration portion of the window is used to configure the PoE port settings.
The following parameters can be set:
Parameter Description
From/To
Specifies a range of ports to be configured.
State
Enables or disables the PoE function.
Priority
Setting the port priority affects power-up order and shutdown order:
•
Power-up order: After a rest, the ports are powered up according to their
priority (critical first, then high and finally low).
•
Shutdown order: When power limit has been exceeded, the ports are shut
down according to their priority (critical first, then high and finally low). if the
Power Disconnect Method is set to Deny low priority port.
Power Limit
Configure the per-port power limit. If a port exceeds 10% of its power limit (according to
the characteristic of PoE chip set), the PoE system will shut down that port. Minimum
setting is 1000 mW and maximum is 16800 mW. Default setting is 15400 mW.
Click Apply to implement changes to the PoE Port Configuation.
User Accounts
Use the User Account Management window to control user privileges. To view existing User
Accounts, open the Administration folder and click on the User Accounts link. This will open the
User Account Management window, as shown below.
Figure 6- 6. User Accounts Management window
To add a new user, click on the Add button. To modify or delete an existing user, click on the Modify
button for that user.
Figure 6- 7. User Accounts Modify Table window - Add