D-Link DES-3828 - xStack Switch - Stackable User Manual - Multiple Image Services
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
53
Active
Select a service for the TFTP server to perform from the drop down window:
•
Download Firmware - Enter the IP address of the TFTP server and specify
the location of the new firmware on the TFTP server. Click Start to record
the IP address of the TFTP server and to initiate the file transfer.
•
Download Configuration - Enter the IP address of the TFTP server, and
the path and filename for the Configuration file on the TFTP server. Click
Start to record the IP address of the TFTP server and to initiate the file
transfer.
•
Upload Configuration - Enter the IP address of the TFTP server and the
path and filename for the switch settings on the TFTP server. Click Start to
record the IP address of the TFTP server and to initiate the file transfer.
•
Upload Log - Enter the IP address of the TFTP server and the path and
filename for the history log on the TFTP server. Click Start to record the IP
address of the TFTP server and to initiate the file transfer.
Image ID
Select the Image ID of the firmware. The Switch can hold two firmware images in its
memory. Image ID 1 will always be the boot up firmware for the Switch unless
specified by the user. Choosing Active will download the firmware to the Boot Up
Image ID, depending on the user’s configuration. Information on configuring Image
IDs can be found in this section, under the heading Multiple Image Services.
Server IP Address
Enter the IP address of the server from which you wish to download firmware.
File Name
Enter the path and filename of the firmware or configuration file that you wish to
upload or download.
Multiple Image Services
The Multiple Image Services folder allows users of the Switch to configure and view information
regarding firmware located on the Switch. The Switch allows two firmware images to be stored in its
memory and either can be configured to be the boot up firmware for the Switch. For information
regarding firmware images located on the Switch, open the Firmware Information link. The default
setting for the Switch’s firmware will have the boot up firmware stored in Image 1, but the user may
set either firmware stored to be the boot up firmware by using the Config Firmware Image window.
Firmware Information
The following screen allows the user to view information about current firmware images stored on the
Switch. To access the following screen, click Administration > Multiple Image Services.