D-Link DES-3828 - xStack Switch - Stackable User Manual - Section 3
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
16
Section 3
Connecting The Switch
Switch To End Node
Switch To Hub or Switch
Connecting To Network Backbone or Server
NOTE: All 24 high-performance NWay Ethernet ports can
support both MDI-II and MDI-X connections.
Switch To End Node
End nodes include PCs outfitted with a 10, 100 or 1000 Mbps RJ 45 Ethernet/Fast Ethernet Network
Interface Card (NIC) and most routers. An end node can be connected to the Switch via a twisted-pair
Category 3, 4, or 5 UTP/STP cable. The end node should be connected to any of the ports of the
Switch.
Figure 3- 1. Switch connected to an end node
The Link/Act LEDs for each UTP port will light green or amber when the link is valid. A blinking
LED indicates packet activity on that port.
Switch to Hub or Switch
These connections can be accomplished in a number of ways using a normal cable.
•
A 10BASE-T hub or switch can be connected to the Switch via a twisted-pair Category 3, 4
or 5 UTP/STP cable.
•
A 100BASE-TX hub or switch can be connected to the Switch via a twisted-pair Category 5
UTP/STP cable.
•
A 1000BASE-T switch can be connected to the Switch via a twisted pair Category 5e
UTP/STP cable.
•
A switch supporting a fiber-optic uplink can be connected to the Switch’s SFP ports via fiber-
optic cabling.