Garmin Cessna Caravan G1000 Pilot's Manual - page 4
Garmin G1000 VHF NAV/COM Pilot’s Guide for Mooney M20M & M20R
190-00445-00 Rev. A
4-2
INTRODUCTION
WINDOWS AND FIELDS
On both the PFD and the MFD, the NAV and COM
Frequency windows are located at the top of the display
on either side of the Navigation Status bar.
• The
NAV Frequency window
is displayed to the
left of the Navigation Status bar.
• The
COM Frequency window
is displayed to the
right of the Navigation Status bar.
Each radio frequency sub-window is composed of two
(2) fields, a
standby field
and an
active field
.
• In the NAV Frequency window, the active frequency
field is located on the right side, while the standby
frequency field is located on the left side.
• In the COM Frequency window, the active frequency
field is located on the left side, while the standby
frequency field is located on the right side.
Standby NAV
Frequency Field
Active NAV
Frequency Field
Active COM
Frequency Field
Standby COM
Frequency Field
Figure 4.1.2 Frequency Fields
Selected NAV
Radio
Navigation Status Bar
Tuning Box
Tuning Box
Selected COM
Radio
RADIO SELECTION
Radio selection is performed as follows:
•
NAV radio selection
is performed via the
CDI
softkey located on the PFD:
– When NAV1 radio is selected, a single green
arrow labeled either ‘VOR1’ or ‘LOC1’ is dis-
played on the HSI.
– When NAV2 radio is selected, a double green
arrow labeled either ‘VOR2’ or ‘LOC2’ is dis-
played on the HSI.
•
COM radio selection
is performed via the
COM1
MIC
or
COM2 MIC
keys located on the audio panel:
–
COM1 MIC
key selects COM1 radio.
–
COM2 MIC
key selects COM2 radio.