Lancia Lybra Owner's Handbook Manual - 109
109
CONTROLS (fig. 102)
Knob for adjusting air
temperature (2, 4 - fig. 102)
Turn the knobs towards the right or
towards the left to raise or lower the
air temperature required respectively
in the left-hand area (knob 2) and in
the right-hand area (knob 4) of the
passenger compartment. The set tem-
peratures are shown on the displays 1
and 3 over the respective knobs.
Press button 14 (MONO) to auto-
matically align the passenger’s side
temperature to the temperature on
driver’s side. Consequently, the tem-
perature in the two areas can be set
simply by turning the knob on dri-
ver’s side 2. This function is provided
to facilitate adjusting the temperature
in the passenger compartment when
only the driver is present.
The separate operation of the set
temperatures is automatically reset
when knob 4 is turned.
Turn the knobs fully to the right or
to the left to the end positions HI and
LO to obtain maximum heating or
cooling, respectively:
– HI function (maximum heating):
this is switched on by setting a tem-
perature higher than 32°C on the dis-
play. It can be independently switched
on from driver’s side or from passen-
ger’s side or from both sides (also by
selecting the MONO function). This
function can be switched on to speed
up heating in the passenger compart-
ment by exploiting the system poten-
tial to the maximum. The function
employs the maximum coolant tem-
perature while the air distribution and
fan speed are set by the system ac-
cording to environmental conditions.
In particular, if the coolant tempera-
ture is not sufficient, the function
does not switch the fan on at top
speed to limit letting into air which is
not adequately warm. All the manu-
ally settings can be adjusted when the
function is on. To switch the function
off, simply set the temperature on the
display to a value lower than 32°C.
– LO function (maximum cooling):
this is automatically switched on by
setting a temperature lower than
18°C on the display. It can be inde-
pendently switched on from driver’s
side or from passenger’s side or from
both sides (also by selecting the
MONO function). This function can
be switched on to speed up cooling
the passenger compartment by ex-
ploiting the system potential to the
maximum. The function cuts out the
heater and switches the air recircula-
tion and the climate control compres-
sor (where fitted) on. The air distrib-
ution and the fan speed are selected
according to the environmental con-
ditions. All the manually settings can
be adjusted when the function is on.
To switch the function off, simply set
the temperature on the display to a
value higher than 18°C.