Lancia Lybra Owner's Handbook Manual - 147
147
Position 1 - five people.
Position 2 - five people + maximum
allowed load in boot.
Position 3 - driver + maximum al-
lowed load in boot.
If your car fits an automatic rear
trim control system, operate the elec-
trical control A (fig. 175) as follows:
Position 1 - one occupant + load in
the boot (to maximum allowed load).
Positions 2 and 3 - do not use.
Position 0 - other conditions.
The electronic headlight adjuster is
not present on versions with gas dis-
charge headlights as in this case head-
light adjustment employs a device
which is operated automatically.
ADJUSTING THE FRONT FOG
LIGHT BEAM
Turn screw A (fig. 176) from under
the car to adjust the fog light beam.
Have the light position checked -
and adjusted, if required - at a Lan-
cia Dealership.
fig. 176
P4T0105
EOBD SYSTEM
The EOBD (European On Board
Diagnosis) system fitted in this car
complies with Directive 98/69/CE
(EURO 3).
This system continuously monitors
the engine emission system compo-
nents. Furthermore, the system warns
the driver of deterioration concerning
the emission system components by
means of the
U
warning light on the
instrument panel.
The objective is to:
– monitor system efficiency;
– warn when failures can increase
emissions over the threshold estab-
lished by the European regulations;
– warn of the need to replace deteri-
orated components.
Furthermore, the system is equipped
with a connector for interfacing with
specific tools used to read the error
codes stored in the control unit mem-
ory along with a set of diagnostic and
engine specific parameters.