Lancia Lybra Owner's Handbook Manual - page 97
96
Is the code on?
Select the EXPERT function and
press either button 17 or 18 until ei-
ther the message “SAFE” or “CODE”
(THEFT-PROTECTION CODE set-
ting) appear on the display (fig. 91):
– SAFE = Code on
– CODE = Code off.
Activating the code
1) Select EXPERT function and
press either button 17 or 18 until the
message “CODE” appears on the dis-
play.
2) Activate setting by briefly press-
ing button 2. The message “- - - -”
will appear on the display.
3) Enter the code with buttons from
2 to 5 (fig. 76).
Button 2 is used to enter the first
code digit, button 3 to enter the sec-
ond digit, button 4 to enter the third
digit and button 5 to enter the fourth
digit.
For example, to enter the code 1 7 0 3,
press button 2 briefly once only. The
message 1 - - - will appear on the dis-
play.
Enter the second digit by briefly
pressing button 3 seven times. The
message 1 7 - - will appear on the dis-
play.
You can now enter the third digit.
Press button 4 ten times. The message
1 7 0 - will appear on the display.
Finally, complete the code by press-
ing button 5 three times. The message
1 7 0 3 will appear on the display.
Press the button longer to decrease
the digit by one unit.
4) To confirm the code: press the
EXP 14 button briefly. The message
“SAFE” will appear on the display.
The code is on.
To quit the EXPERT function: press
the EXP 14 button for approximately
three seconds.
Deactivating the code
1) Select the EXPERT function and
press buttons 17 or 18 until the mes-
sage “SAFE” (THEFT-PROTEC-
TION CODE setting) appears on the
display.
2) To activate settings, press button
2 briefly. The message “1 - - - “ will
appear on the display.
3) Enter the code (see “Safety code”)
as described in “Activating the code”
by pressing the buttons numbered
from 2 to 5.
4) Confirm the code by pressing the
EXP 14 button briefly until the mes-
sage “CODE” appears on the display.
The code is no longer active.
IMPORTANT If an incorrect code is
entered, the message “SAFE” will be
shown on the display. Repeat the en-
tire procedure. Respect stand-by
times between attempts (see “Stand-
by times”).
fig. 91
P4T0626