Lancia Lybra Owner's Handbook Manual - 188
188
The bulbs of (Xeno) gas-
discharge headlights must
be replaced by a Lancia
Dealership.
DIPPED AND MAIN BEAM
HEADLIGHTS, FRONT SIDE
LIGHTS
The dipped beam, main beam head-
lights and the front side lights are
housed in the front headlight cluster.
Press the upper tab A (fig. 23) and
remove the cover B. To refit the cover
B, insert tab C first then press on the
upper part of the cover to clip tab A
into place.
The bulbs are arranged as follows
(fig. 24):
1) Dipped beam headlight
2) Main beam headlight
3) Front side light
Dipped beam headlight (fig. 25)
To replace the halogen E, 12V- H7/
60W bulb:
1) Remove the connector from the
bulb.
2) Release the fastening clip A and
remove the bulb.
3) Insert the new bulb. Make the tab
B on the metal part of the bulb coin-
cide with the specific groove on the
headlight dish.
4) Refit the fastening clip and refit
the connector.
fig. 24
P4T0128
fig. 23
P4T0127
fig. 25
P4T0736
IF AN EXTERIOR BULB BURNS OUT
IMPORTANT For the type of bulb
to be used and the relevant power, see
the summary table at the previous
chapter “If a bulb needs replacing”.