Lancia Lybra Owner's Handbook Manual - 181

181

9) Position the jack under the car

near the wheel to be replaced in the

points shown on the panelling under

the door:

– position 1 (fig. 7) to change a front

wheel

– position 2 (fig. 8) to change a rear

wheel

10) Turn the handle F on the jack

(fig. 9) by hand so to open it partially

and position the jack under the car. 

11) Extend the jack until groove G

(fig. 9) on the jack fits onto the bot-

tom edge H of the underbody cor-

rectly.

12) Warn anyone nearby that the

car is about to be lifted. They must

stay clear and not touch the car until

it is back on the ground.

13) Work the jack with handle L

(fig. 10) until the car is a few cen-

timetres off the ground. Make sure

that the handle turns freely and is far

enough from the ground so that you

do not scrape your hands. Do not

touch moving parts of the jack

(screws or joints) as they can cause

injuries. If you dirty your hands with

grease, clean them carefully.

14) Loosen the wheel bolts and re-

move the wheel.

fig. 8

P4T0115

fig. 7

P4T0114

fig. 9

P4T0116

fig. 10

P4T0117