Lancia Lybra Owner's Handbook Manual - 184
184
4) For cars fitted with alloy rims:
fasten the pin provided B (fig. 18)
onto the hub, then fit the wheel and
tighten the three bolts. Remove the
pin B and fasten the last bolt.
5) Tighten the bolts using the hexa-
gon on upper part of the provided
screwdriver and holding the tool with
the screwdriver blade inserted in the
hole on the handle (fig. 19).
6) Lower the car and remove the
jack.
7) Tighten up the wheel bolts in a
criss-cross fashion following the order
shown (fig. 20).
8) Position the cap on the wheel rim
with the inflation valve C (fig. 21) co-
inciding with the recess. Press all
round the cap starting from the valve
until it is fitted properly.
9) For cars fitted with alloy rims: ex-
ert a light pressure to refit hub cap.
IMPORTANT Failure to fit the cap
properly could result in it flying off
when the car is moving.
fig. 18
P4T0125
fig. 19
P4T0119
fig. 21
P4T0123
fig. 20
P4T0126