Lancia Lybra Owner's Handbook Manual - 122
122
GENERAL
The electronic cruise control allows
to drive your car at the required speed
without pressing the accelerator
pedal. This reduces fatigue when dri-
ving on motorways because the set
speed is automatically maintained.
IMPORTANT The device can only
be set to speeds exceeding 30 km/h.
fig. 118
P4T0307
The cruise control must
only be used when the
traffic and road conditions
allow to keep a constant speed in
total safety for an adequately long
time.
The device is automatically switched
off when:
– the brake pedal is pressed
– the clutch pedal is pressed.
CONTROLS (fig. 118)
The cruise control is operated
by means of switch A, ring B and but-
ton C.
Switch A has two position:
– OFF: in this position, the device is
off;
– ON: this is the normal device op-
erating position. The CRUISE warn-
ing light D will come on when the de-
vice starts governing the engine.
Ring B is used to set and maintain
the car speed or decrease the set
speed.
Turn ring B to position (+) to set the
speed reached or to increase the
stored speed.
Turn ring B to position (–) to de-
crease the stored speed.
The speed will be increased or de-
creased by approximately 1 km/h
each time ring B is operated. Hold the
ring turned to set the speed continu-
ously. The new set speed will be au-
tomatically kept.
Button C allows to reset the stored
value.
IMPORTANT Turn the ignition key
to STOP or switch A to OFF to delete
the stored speed and switch the sys-
tem off.
CRUISE CONTROL
(where fitted))